Power Probe 4 Master Tester Kit – Power Probe PPKIT04

Description

Power Probe 4 Master Tester Kit

Fitment

Universal

The Power Probe 4 Master Combo Kit combines the Power Probe 4, PPECT3000, and various accessories to provide the ultimate combination of diagnostic and circuit-testing capabilities. The Power Probe 4 provides simplified testing of Motors, Lights, Relays, and Sensors, and even Fuel Injectors. Also, like all Power Probe circuit-testers, it supplies Power and Ground for functional component testing on or off the vehicle. The PPECT3000 will help you trace short and open circuits quickly and accurately.

Content:

• Power Probe 4 Red
• ECT3000 Transmitter
• ECT3000 Receiver
• Power Probe Tip
• 3 Light Bulb Adapters
• Universal Adapter
• Alligator Clip Adapter
• Blade Probe Adapter
• Back Probe Adapter
• Small Piercing Probe
• Large Piering Probe
• Battery Clip set
• Battery Clip set for the PP4
• 3ft Lead
• Self-resetting Circuit Breaker
• AAA Batteries

Features:

• Supply Power or Ground for Functional Component Testing
• Self-Resetting Thermal 8 Amp Circuit Breaker
• Multiple DC Volt readings on the same display
• Ohmmeter provide active feedback
• 12 – 24 Volt Range
• Bad Ground Indicator
• Continuity Tester
• Component Tester
• AC-RMS, AC Peak to Peak, Frequency and Pulse Width indicators are available for signal testing
• Fuel Injector tester for easy circuit diagnosis
• PCM/ECM Driver supplies safe voltage for testing computer driver circuits
• PPECT Mode for signal detection of open circuits
• Active LED Lighting for illuminating workspace
• Power Cable Length of 23 Feet

Typical Response

8 amps   |  10amps  |   15amps  |   25amps   | Short Circuit
No Trip  |   20min   |     6 sec.   |       2 sec.    |      0.3 sec.

• Trace Out a Short Circuit to Chassis Ground
• Tracing Out a Battery Drain or Current Draw
• Isolate your Circuit
• Verify the Short Circuit to Ground
• Verify an Open Circuit
• Short Circuit inside a wire harness
• Reception Distance from 1 inch to 8 inches
• Tracing Circuits that are shielded (Plastic Panels, Pillars, and Carpet)
• Shut off time is now 10 mins

Transmitter Spec

• Min Operating Voltage 8 VDC
• Max Operating Voltage 48 VDC
• Working Current: 200mA
• Working Frequency: 4KHz
• Max Operating Relative humidity: 80% ( Non-condensation)
• Max Storage Relative humidity: 80 % (Non-condensation)

Receiver Spec

• Power Supply: 2 x 1.5V AAA
• Working Current: When not signal be detected <15mA
• Power Consumption when power off:<10uA
• Max Operating Temp: 50°C
• Max Storage Temp: 70° C
• Max Operating Relative humidity: 80% (Non-condensation)
• Max Storage Relative humidity: 80% (Non-condensation)